NorthStar M157310C, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 23

7
II.) Assembly Instructions
III.) Pump Preparation
A.) Remove shipping tape and make sure the oil is 1/2
way up oil sight glass.
IV.) Engine Preparation
A.) Fill engine with 1.16 qt of oil.
B.) Fill fuel tank with unleaded gasoline, 86 octane min.
Quantities Of Fluid
Engine/Pump Type of Fluid QTY
Honda GX390 SAE 10W30 1.16 qt (1.1L)
Cat 66DX SAE 30** 18oz (0.55L)
**SAE Non-Detergent (Item# 4043)
V.) Battery
Warning: Sulfuric acid is a corrosive poison.
Av oid contact with skin, eyes or clothing. Alw ays
wear safety glasses w hen w orking on or near the
battery.
The battery box provides protection for the battery and
will accept a standard lawn tractor size battery (Group
U1-7). The engine requires a 12-volt battery, with a
minimum rating of 18 Ah (Amp-hour). When installing a
battery, always connect the red colored (“positive” or “+”)
cable first. When disconnecting a battery, always
remove the black colored (“negative” or “-”) cable first.
LIFT BACK OF UNIT BY HANDLES TO INST ALL
REAR WHEELS, THEN LIFT FRONT OF UNIT TO
INSTALL FRONT WHEELS
INSTALL WHEEL ONTO AXLE
FASTEN WHEEL WITH RETAINER,
SECURE RETAINER WITH WR ENCH PROVIDED
NOTE : IT I S RECOMMENDED THAT TWO PEO PLE
LIFT THIS UNIT WHILE A THIRD SLIDES THE
WHEELS ONTO THE AXLES
PRESS BRAIDED HOSE ONTO
INJECTOR AND STRAINER
FASTEN HANDLES TO FRAME WITH
5/16 X 3/4” BOLT S AND 5/16 NUTS
INSTALL GROMMETS
AND NOZZLES INTO
HOLES IN FRAME