
13
Initial Set-up
Spray Gun Assembly
Attach the Lance to Spray Gun
Tighten spin-on coupler hand tight.
Note: The O-rings create a seal so there is no need to
tighten with a wrench
Wall Mount Hook, Gun and Hose Assembly
1.
Install wall mount Hook, gun and hose # 803190
using self-tapping screws qty-4 (Screws are not
supplied with unit) against flat surface of the wall.
2.
Store gun after removing lance and hose on hook.
Step 3. Select Suitable Location
Moving and Handling
WARNING
Lifting Hazard
The pressure washer is heavy. It can crush and cause
serious injury if it rolls out of control or tips over. Follow the
instructions below for safely moving the pressure washer.
Elevating or lowering your pressure washer
•
To reduce risk of injury, it is recommended that two
adults lift the pressure washer, or a lifting device is
used such as an overhead hoist or forklift.
•
Only lift the pressure washer by the base. Do not
use the pump or motor as lifting point. See
component identification for lifting point locations.
Positioning:
1.
The pressure washer should be positioned on a
firm, level (less than 3-degree slope), heat-
resistant surface with good drainage and a nearby
water supply.
2.
The pressure washer should be placed within
garden hose distance of a continuous water
supply. Ensure that the pressure washer sits level
and will not slide or shift during operation.
Airflow
:
1.
Situate so there is adequate clearance around
pressure washer to allow for airflow
–
at least 7
feet from any non-combustible wall or obstruction.
2.
Do not operate with a tarp, blanket, or cover
surrounding the pressure washer.
3.
Do not place any objects against or on top of the
pressure washer.
4.
The pressure washer needs adequate,
unobstructed flow of air to allow for adequate
cooling. Cooling ventilation is required to prevent
overheating of the pressure washer and possible
fire.
5.
Keep a fire
extinguisher rated “ABC” nearby.
Step 4. Verify Electrical Connection
Grounding
Product must be grounded. The supply cord is equipped
with an equipment-grounding conductor and a
grounding plug. This plug must be plugged into an outlet
that is properly installed and grounded in accordance
with all local codes and ordinances.
Ground Fault Circuit Interrupter Protection
Connecting the pressure washer through some type of
ground fault circuit interrupter (GFCI) protector is
required to comply with the National Electric Code
(NFPA 70) and to provide additional protection from the
risk of electric shock.
SPIN- ON COUPLER
LANCE
Содержание 1571101
Страница 11: ...11 Initial Set Up Hardware Bag ...
Страница 27: ...27 Parts Explosion REV B ...
Страница 37: ...37 This page is left intentionally blank ...