Northern IP3VFB, Инструкция по установке и быстрой настройке

Страница: 13 / 31

11
•
Make sure that there is no re fl ec ti ve surface too close to the
camera lens. The IR light from the camera may re fl ect back into
the lens causing re fl e cti on.
•
The foam ring around the lens must be seated fl ush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring
and the dome cover are a
tt ached seamlessly.
2.1 SD Card Installation
Steps:
1. Rotate the lock screw counterclockwise to loosen it. Slide the sun
shield according to the arrow direc ti on as shown in 0(le ft ).
2. Remove the sun shield as shown in 0(right).
3. Remove the front cover by rota ti ng it counterclockwise as shown
in 0(right).
Figure 2-1 Disassemble the Camera
Lock Screw
12
4. Insert the SD card to the SD card slot.
5. Rotate the front cover clockwise back to the camera and install
the sun shield according to the arrow direc ti on as shown in Figure
2-2(right).
Figure 2-2 Install the SD Card
6. Slide the sun shield according to the arrow direc ti on as shown in
Figure 2-3(le ft ).
7. Rotate the lock screw clockwise to ti ghten the sun shield.
Installation & Quick Setup Guide Installation & Quick Setup Guide