Northern Lights M864W, Руководство оператора

Страница: 21 / 56

OM864W 10/18
19
SP-5. V-BELTS
1. Check the tension and wear on the V-belt after
every 50 hours.
2. Use your thumb to press on the belt at the midpoint
between the crankshaft and alternator pulleys. The
tension is correct if the belt can be depressed about
3/8 in. (10 - 15 mm) with 22 lbs. (10 kg) force.
SP-3. CHANGING LUBE OIL FILTER
1. Change the lube oil filter every 200 hours.
2. Use a filter wrench to remove old filter. Dispose of
filter in approved manner.
3. Make sure the gasket from the old filter is removed
and discarded. Clean mount face.
4. Spread a thin film of engine oil on the rubber gasket
on the new filter and screw it on nipple until gasket
meets the sealing surface.
5. Using hands only – no wrench – tighten filter
one-half turn farther. Overtightening can do
damage to filter housing.
6. Fill engine with recommended oil. Start engine and
check for leakage. Stop engine, wait 3 minutes, and
check oil level. Add additional oil if necessary.
7. Oil filter part number is:
Model 864W & W3 ................................... #24-08701.
SP-4. AIR CLEANER
1. Visually inspect air cleaner every 200 hours. In dusty
conditions, check more often.
2. Remove the plate on the side of the air intake mani-
fold. Remove and inspect the foam element.
If dirty, wash element in soapy water. Rinse and
dry thoroughly before reinstalling.
NOTE: Make absolutely sure no impurities enter
the engine while changing the element, and
do not run the engine with the air cleaner
removed.
Do not clean the filter with diesel fuel,
solvent, or gasoline. Serious engine damage
can result.
Servicing