Northern Lights M864W, Руководство оператора

Страница: 18 / 56

OM864W 10/18
16
The Servicing Schedule Chart below shows the service schedule required for proper maintenance of your generator set.
More detailed coverage of each Service Point (SP) is listed on the page noted in the ‘page’ column.
DAILY:
SP1 Check oil level in engine
SP7 Check primary fuel filter
SP13 Check cooling water level
Check sea strainer
AFTER FIRST 50 HOURS:
SP2/3 Change engine oil and filter
SP5 Check V-belt tension
SP6 Adjust valves
SP18 Check electrolyte level in batteries
EVERY 50 HOURS:
SP5 Check V-belt tension
SP18 Check electrolyte level in batteries
AFTER FIRST 100 HOURS:
SP2/3 Change engine oil and filter
EVERY 200 HOURS:
SP2/3 Change engine oil and filter
SP4 Check air cleaner
SP8 Change primary fuel filter element
SP9 Change secondary fuel filter
SP17 Check zinc electrodes
EVERY 750 HOURS:
SP6 Check valve clearances
SP11 Check injectors
SP14 Check and flush cooling system
SP16 Change impeller
SP18 Check state of charge of batteries
EVERY 1500 HOURS:
SP11 Check injectors, clean tips
EVERY 2400 HOURS:
SP12 Check fuel injection pump
SP27 Check and clean heat exchanger
EVERY 3000 HOURS:
SP11 Remove injectors for adjustment, clean & repair
Servicing Schedule Chart
SERVICE
50 100 200 750 1500 2400 3000
POINT
PAGE OPERATION DAILY Hours Hours Hours Hours Hours Hours Hours
ENGINE:
SP1 18 Check oil level
•
SP2 18 Change engine oil
1, 5
• •
SP3 19 Change lube oil filters
1, 5
• •
SP4 19 Check air cleaner
1, 4
•
SP5 19 Check V-belt tension
1
•
SP6 20 Check valve clearances
5
•
FUEL SYSTEM:
SP7 21 Check primary filter
2
•
SP8 21 Change primary filter element
2, 3
•
SP9 21 Change secondary fuel filter
1, 3
•
SP10 22 Bleed the fuel system
3
SP11 23 Check injectors
1, 6
• • •
SP12 24-25 Check fuel injection pump
•
COOLING SYSTEM:
SP13 26 Check cooling water level
•
SP14 26 Check and flush cooling system
•
SP15 27 Check and clean heat exchanger
•
SP16 27 Change impeller in raw water pump
1, 3
•
SP17 27 Check zinc electrodes
4
•
ELECTRICAL SYSTEM:
SP18 29 Check electrolyte level in batteries
1, 4
•
SP19 29 Check condition of batteries with hydrometer
1
•
OUT OF SERVICE:
SP20 29 Winterizing or out-of-service
3
1) Perform all maintenance once a year even if hour level has not been reached.
2) Consult manufacturer's maintenance schedule, note on chart.
3) Whenever necessary.
4) More often if necessary.
5) After first 50 hours.
6) To insure that your engine stays in compliance with applicable EPA
& CARB emission standards, the following additional maintenance
procedures & intervals must be maintained.
1500 Hours: Fuel injectors are to be removed & injector tips cleaned.
3000 Hours: Fuel injectors removed for adjustment, cleaning, & repair.