OM673 09/09
Control Panels
6
Figure 7-A: Series 7.1 through Series 7.6 Generator
Control
Panels.
Figure 7-B: Status Indicators for Series 7.3 through
Series 7.6 Generator Control Panels.
1. SHUTDOWN BYPASS SWITCH
Manual Start Panels
(S-7.0 and S-7.3)
Hold the switch in the on position for approximately
10 to 20 seconds before starting a cold engine. Hold-
ing the switch on for too long can burn out the glow
plugs. To start the engine the bypass switch must be
held on while moving the engine control switch into
the start position. As soon as the engine starts release
both switches.
Auto Start Panels
(S-7.2, S-7.4, S-7.5, and S-7.6)
When the switch is in the auto start position, the unit
will start upon closure of auxillary contacts. Moving
the switch to the manual position will start the engine
and it will run after the control timers have completed
their sequence.
2. OIL PRESSURE GAUGE
Shows the oil pressure in the engine lubricating system.
3. HOUR
METER
Keeps track of engine running time.
4. ENGINE TEMPERATURE GAUGE
Registers the temperature of the coolant.
5. D.C.
VOLTMETER
When the engine is running, the voltmeter indicates the
voltage output of the alternator.
6. STATUS INDICATOR PANEL
Engine monitoring alarms and lamps for monitoring
engine functions.
7. ALARM LAMP TEST AND RESET BUTTON
Press UP to test the indicator lights and press DOWN
to reset the alarm.
8. A.C. VOLTAGE ADJUSTMENT RHEOSTAT
Voltage has been set at the factory and should only be
adjusted by factory-trained personnel.
9. AMMETER SELECTOR SWITCH
Used to check each phase for load condition.
NOTE: Always leave this switch in the ON position
while the unit is running.
10. FREQUENCY METER (HERTZ)
The frequency meter indicates alternator current fre-
quency: 60 Hz (1200 or 1800 RPM), or 50 Hz (1500
RPM).
11. A.C. VOLTMETER
Shows the generator output voltage.
12. A.C. AMMETER
Shows the generator load on each phase. The phase is
selected with the Ammeter Selector switch (
Item 9
).
Содержание Lugger M673D
Страница 12: ...OM673 09 09 Notes 10 ...