Northern Lights Lugger 0844K, Руководство оператора

Страница: 14 / 30

O844K 10/09
Servicing
LUbRICATION - gENERAL
1. Use only clean, high quality lubricants stored in
clean containers in a protected area.
2. These lubricants are acceptable:
a. API Service CC/CD/CE single viscosity oils.
b. API Service CC/CD/SF multi-viscosity oils.
3. Use the proper weight oil for your average opera-
tion temperature.
Figure 5: Lube oils
4. Some increase in oil consumption may be
expected when SAE 5W and SAE 5-20W oils are
used. Check oil level frequently.
5. Never put additives or flushing oil in crankcase.
SP1. ChECKINg OIL LEvEL
1. Check the oil level in the crankcase with the dip-
stick. The oil level must be in the waffled area
on the stick. Never allow the level to go below
this area. Follow the lubrication recommendations
above.
SP2. OIL ChANgES
1. The set is delivered with special break-in oil.
Change the engine oil and oil filter after 50 hours
of operation. Use Service CC 30 weight oil during
the first 100 hours.
2. Change the oil and filter again at 100 hours using the
oil recommended in the above diagram. After this,
change oil and filter every 250 hours.
3. During intermittent cold weather operation, change
oil every 100 hours or six weeks, whichever comes
first.
4. Change oil at the end of each season and the begin-
ning of each season.
5. Change oil when engine is warm.
6. Dispose of waste oil in an approved manner.
7. Never use a flushing oil.
8. Loosen the clamp on the oil change tube. Remove
cap. Drain oil. Replace the cap and tube.
9. Refill engine with recommended oil for the season.
10. Engine capacity with new oil filter is:
844
k
and 844L
k
– 2.1 gallons (8.2 liters)
SP3. ChANgINg LUbE OIL fILTER
1. Change the lube oil filter every 100 hours.
2. Use a filter wrench to remove old filter. Dispose of
filter in approved manner.
3. Make sure the gasket from the old filter is removed
and discarded. Clean mount face.
4. Spread a thin film of engine oil on the rubber gasket
on the new filter and screw it on nipple until gasket
meets the sealing surface.
5. Using hands only – no wrench – tighten filter
one-half turn farther. Overtightening can do
damage to filter housing.
6. Fill engine with recommended oil. Start engine and
check for leakage. Stop engine, wait 3 minutes, and
check oil level. Add additional oil if necessary.
7. Oil filter part number is:
844
k
and 844L
k
– #24-03100
Air Single Multi-
Temperature viscosity viscosity
Above 32°F
SAE 30W SAE 15-40W
(0°C)
-10 to 32°F
SAE 10W SAE 10-30W
(-23 to 0°C)
Below -10°F
SAE 5W SAE 5-20W
(-23°C)
12