Northern Lights Lugger 0844K, Руководство оператора

Страница: 11 / 30

O844K 10/09
9
ShUTdOWNS ANd ALARMS
1. Your unit is fitted with a system to protect it from
high water temperature or low oil pressure.
a. Generator sets have shutdown systems to stop the
engine. They have no warning horns.
b. Other alarms and shutdowns are available as
optional equipment.
NoTe: Do not rely on your warning to the exclu-
sion of careful gauge monitoring. Watching your
gauges can prevent damage to the unit and danger-
ous power losses.
2. Do the following when your warning or shutdown
system is activated:
a. Check the temperature gauge.
Marine sets: If above 205°F (96°C), shut off the
engine immediately.
b. Use the Trouble Shooting Guide on page 22 to
isolate the cause of the overheat.
CAUTION: Do not remove the water fill
cap of an overheated engine. escaping high
temperature steam can cause severe burns. Allow
the engine to cool and then remove the cap slowly
using protective clothing.
d. Make repairs. Restart your Marine set after the
temperature gauge registers below 200°F (94°C).
e. Watch the temperature gauge regularly and
turn off the unit if the temperature rises
above 205°F (96°C) on Marine units.
Repeat troubleshooting.
3. If shutdown is activated and the temperature gauge
shows temperature within normal temperature range:
a. Check the engine crankcase oil level.
b. If the oil level is low, fill with recommended
lubricating oil and restart. Watch the oil pressure
gauge carefully and shut off the engine if it does
not show a normal reading (20-60 PSI) after a
few seconds of operation.
c. If the oil level is normal, DO NOT restart the
engine. Call your dealer for assistance.
SPARE PARTS
1. Northern Lights recommends that you keep the
following spare parts on hand for field service. The
parts are available from your local Northern Lights
dealer.
Some marine models already have “On-Board-Kits,”
a handy box that contains the most common parts
you will need.
2. All owners should have the following spares:
a. Primary and secondary fuel filter elements
b. Oil filters
c. Air filter
d. Alternator belt
e. Thermostat and gaskets
f. Seawater pump impeller & gaskets (marine only)
g. Glow plug
h. Injector and washer
3. If your set is operating a long distance from a servic-
ing dealer, add the following:
a. Complete set of injectors
b. Copper washers for injector change
c. Complete set of glow plugs
d. Fuel lift pump
Operating Procedures