13
14
ADJUSTING DRIVE ROLL TENSION
SETTING FRONT PANEL CONTROLS
Test drive roll tension by feeding wire into a gloved hand from
about 4 inches away. Loosen drive roll tension to apply little
pressure. Slowly increase drive roll tension until the wire coils up
in your hand without slipping in the drive rolls.
On the wire compartment access panel is a set-up guide. Find the
type of material being welded and the size of wire you are using.
Slide over to the thickness of the thinnest material you are weld-
ing. Set the voltage and wire feed speed on the front of the unit.
15
ATTACH GROUND CABLE TO WORK
Attach the ground cable to the welding table or work-piece.
Wire Feed Control
Voltage
Control
