1
INSTALLING A 4” SPOOL OF WIRE
2
DRIVE ROOL - USE KNURLED GROOVE
5
6
FEED WIRE - OPEN TENSION ARM
9
10
FEED WIRE - REMOVE GUN TIP & NOZZLE
FEED WIRE - PULL TRIGGER TO FEED WIRE
Remove wing nut, washer and black bushing. Slide on spool so
wire feeds off the bottom of spool. Reinstall bushing, washer and
wing nut. See Step 12 to adjust wire spool tension.
Always make certain that the knurled groove is in line with the
wire when installed on drive shaft.
Open the drive roll tension arm on the wire feeder.
To finish feeding the wire through the gun, you will need to
remove the gun nozzle and tip.
Stretch out the gun. Turn on input power and pull the trigger to
feed the wire through the gun. Stop when the wire pushes through
the end of the gun.
Tighten
Clockwise
Knurled Groove
INSTALLING UNIT HANDLE
The handle for this unit is supplied along with the hardware to
secure it. Locate the handle and hardware and install as shown
Drive Roll
Tension Arm
