Page 3
Figure 4
PRESSURE MOUNTING
Pressure Mounted maximum opening size 40” (if
opening is greater than 40” use Door sockets).
STEP 1
Place gate on floor with handle on the opposite side of
area accessible to the child, expand the gate so that all
four bumpers are in contact with sides of the opening.
STEP 2
Rotate locking handle and insert handle tab into the
slot that gives you enough tension to secure the gate.
STEP 3
To release locking handle press down on it lightly, twist
it outwards, and pull gently away from the gate.
PRESSURE MOUNTED USING DOOR
SOCKETS
(On Openings over 40”)
Always use tape pads when using mounting sockets.
Note: Foam tape may leave a foam residue or damage
some wall surfaces when removed. Screws, in
addition to tape, may be used for added security. Four
longer screws are provided in hardware package.
STEP 1
Place tape pads in recessed area of door sockets.
STEP 2
Place gate on floor and expand in the opening. Be sure to
adhere the door sockets to the opening wall or surface
where the four bumpers touch. Remove the protective
cover sheet from one of the door sockets and with the “U”
upright, stick in place. Do the same on the opposite side.
The gate should be mounted flush to the floor (or no more
than 1
1
/
2
” above the floor).
STEP 3
Mount the gate by aligning the four bumpers in the
door sockets and rotating the handle and locking it
into the slot that gives you enough tension to secure
the gate. See Figure 2.
STEP 4
To release the locking handle, press down on it
lightly, twist it outwards, and pull gently away from
the gate.
Figure 1
Figure 2
Figure 3
Figure 6
INSTALLATION AND OPERATING INSTRUCTIONS
Figure 5
