10
PROGRAMMING THE
ELECTRONIC DEMAND
TIMER
up
button
display
SELECT button
down
button
RECHARGE button
"
TIMER SETTINGS REQUIRED
...upon installation, and after an extended power outage (see Pro-
gram Memory, page 18).
NOTES:
D
WHEN THE POWER SUPPLY IS PLUGGED INTO THE ELECTRICAL OUTLET (STEP 10, PAGE 9), a
flashing
12:00AM
and
PRESENT TIME
show in the display area. Program the timer as instructed below.
If
- - - - is flashing
,
use the UP
+
button to set the code to
Sr14
. If you pass by the correct code number, use
the DOWN
--
button. Then, press the SELECT button and program the timer below.
If the wrong code shows
for your model,
see Manual Initiated Electronic Diagnostics on pages 19 and 20.
D
A ‘‘beeper’’ sounds while pressing buttons for timer programming. One beep signals a change in the timer
display. Repeated beeps means the timer will not accept a change from the button you have pressed, and
you should use another button.
D
To set the timer, you will use the UP
+
, DOWN
--
and SELECT buttons.
"
SET PRESENT TIME OF DAY
NOTE:
If the words
PRESENT TIME
do not show in the display, press the SELECT button until they do.
1.
Press the UP or DOWN button to set. The UP
button moves the time ahead; DOWN moves the
time backward.
NOTE: Each press of the buttons changes the
time by one minute. Holding the buttons in
changes the time 32 minutes each second.
If the present time is between noon and midnight,
be sure PM shows.
If the present time is between midnight and noon,
be sure AM shows.
2.
When the present time shows, press SELECT
to set.
