North Star 1574210, Руководство пользователя, Страница: 11 / 64

11
Assembly and Initial Set-Up
Step 1. Inspect & Unpack
Inspect the pressure washer immediately after you
receive delivery for missing parts or damage. Find and
separate components identified in Fig.1574210_3 and
Figure 1574210_4.
•
For missing or damaged components, contact Product
Support at 1-800-270-0810.
Fig.1574210_3 – Pressure Washer Components
Fig.1574210_4 – Parts to be installed
Step 2. Assembly
You must assemble your pressure washer before it can
be used. Refer to Fig.1574210_5 and follow the steps
listed below:
•
Install handle with six (6) 5/16"-18 x 3/4" Flange
bolts through base and handle and secure with
six (6) 5/16"-18 Flange bolts.
•
Install Hose Hook into right side of handle using
two (2) M8 Nuts.
•
Install GFCI Cord Hook into right side of handle
using two (2) M8 Nuts.
•
Install Nozzles into designated nozzle storage
location.
Step 3. Initial Pump & Motor Preparation
Prepare Water Pump
Verify pump oil level. Refer to Fig.1574210_6 and follow
the steps listed below.
NOTE: The Pump is shipped with oil.
•
Remove shipping tape and black vent plug (if
present) from oil fill cap.
•
Verify that oil level is halfway up the sight glass.
•
If oil level is low, use the oil type from below table.
See page no.13.
High Pressure Hose
Qty-1
799880
Spray
Gun
Qty-1
779165
Lance
Qty-1
791278
Handle Weldment
Qty-1
800080
Pressure Washer
Fig.1574210_3
Spray Gun
Qty-1
777420
Lance
Qty-1
777421
Hardware Bag
Only For 1574213
Fig.1574210_5
INSTALL HOSE
HOOK
INTO HANDLE
USING TWO (2)
M8-1.25
NYLOC NUTS
INSTALL GFCI CORD
HOOK
INTO HANDLE
USING TWO (2)
M8-1.25
NYLOC NUTS
5/16-18 X
3/4" SIX
(6)
FLANGE
BOLTS
5/16-18 X
3/4" SIX
(6)
FLANGE
NUTS
INSTALL
NOZZLES
INTO
DESIGNATED
NOZZLE
STORAGE
LOCATION