4
it counterclockwise. Press down
the spring pin so that the rotary
table is free to turn. When the
desired angle on the base scale
matches up with the arrow
marked on the rotary table, turn
the hand shank clockwise to
tighten it.
SET A BEVELING
ANGLE
Only when the auxiliary stopper
is fixed on the left side (as
shown) can the saw blade be
beveled to a 45 degree angle.
To adjust a beveling angle,
loosen the fixed handle, then
incline the saw blade to the left
until the indicator reaches the
desired angle on the miter
square. Tighten the fixed handle
firmly.
SECURE THE WORK
PIECE
The vertical vise can be installed
in hole of guide bar or the work
piece supporter component
(selective purchasing). Install the
vise rod in the hole of the guide
bar or work piece supporter
component, then tighten the bolt.
You should adjust the position of
the vise arm according to the
thickness and shape of the work
piece and tighten the vise arm
with the bolt. Lean the work
piece against the guide bar and
the rotary table and place the
work piece on the desired cutting
position then tighten the clamp
bolt to secure the work piece.
KEEP THE MAXIMUM
CUTTING CAPACITY
Before any adjusting, unplug the
saw from the power source. This
machine has been adjusted by
the manufacturer to keep the
maximum cutting capacity using an
8 inch saw blade. When the
diameter of the saw blade becomes
smaller because of grinding, please
adjust the machine as follows:
Lower the carriage to the cross bar,
completely put down the handle to
the lowest position. Make sure the
blade is properly aligned. Unplug
the cord and use your hand to spin
the blade. The blade should spin
smoothly without making contact
with any other part of the saw. If
there is contact, realign the blade
before using the saw. With the
socket wrench, turn the adjustable
bolt to make the edge of the saw
blade fit into place, ensuring that it
falls slightly below the rotary table.
Make sure that the saw is
unplugged, then press the handle
to the lowest position to ensure that
the blade does not touch the table
below. Then, if necessary, adjust
the blade.
Note:
Before installing the new saw
blade, make sure it does not
contact any part of the table below.
MAXIMUM CUTTING CAPACITY
2 x 12 1/2 inch
2 x 8 1/2 inch
4 x 10 inch
4 x 12 1/2 inch
0
45°
45°
0
45°
45°
0
0
