3
MOVEABLE HOOD
When sawing, the movable
hood will be lifted up by the
work piece. The movable hood
will automatically be reset to its
original position when the
handle is raised after you finish
cutting. Never abandon or
remove the movable hood.
SAWDUST
COLLECTOR
You can operate this machine
more conveniently with the
sawdust collector. Connect the
adapter of the collector to the
nozzle of the protective cover,
and then fix the collector inlet to
the adapter of the collector.
When the sawdust collector is
half full, take the collector off
from the protective cover, open
the collector door at the bottom,
and clean out the sawdust.
OPERATING THE
SWITCH
To prevent accidental starting,
this tool is equipped with a
protective switch. To start the
tool, you should first press the
protective switch and press down
the trigger switch. When you
release the trigger switch, the
tool is switched off.
OPERATION
1.
Press Cut
(cut small work
piece)
The work piece size within the
scope: 4in. (H) x 13in. (W) can
be cut in the following way.
Push the carriage to the end
towards the cross bar, tighten the
knob to fix the carriage. Use the
vise to secure the work piece.
Switch the machine on, wait until
the saw blade reaches its
maximum speed, and then press
the handle downwards slowly. After
you have finished cutting, turn the
switch off and wait until the saw
blade comes to a complete stop
before raising the handle
completely.
2.
Slip cut
(cut wide work pieces)
The work piece size within the
scope: 4in. (H) x 8 1/2in. (W) can
be cut in the following way.
Release the knob in order to slip
the carriage freely, completely pull
the carriage towards the operator.
Switch the machine on and wait
until the saw blade reaches its
maximum speed, then press the
handle and push it to the cross bar
in order to cut the work piece. Once
you have finished cutting, turn the
switch off and wait until the saw
blade comes to a full stop, then
raise the handle completely.
SET A BEVELED JOINT
ANGLE
Loosen the hand shank by turning
