6
Connection to the power supply
and mounting of the extension
cable
This product adapts to voltages of
120V.
Note:
Use only connection or an
extension cable with a maximum
length of 100 ft. and a minimum cable
diameter of 12 gauge.Extension cable
is to be secured by the clamp, in
order to avoid contact with the cutting
saw during operation.
Adjust the rear handle angle
Press the angle adjusting knob, then
rotate the pole saw handle to the
designated position, then release the
knob to lock the handle in position.
Start and Stop the Pole Saw
1. To start: Press the lock button
first, then press the switch trigger
of pole saw, after that, release the
lock button.
2. To stop: Release the switch
trigger, this will stop the machine.
Chain Oil
Regularly check the oil tank to
ensure that the tank is never
empty during operation.
WARNING: Do not touch the
transmission gear, it gets hot
during operation.
1. Clean the oil tank lid and
surrounding area to avoid dirt
falling into the tank.
2. Fill the tank with lubrication oil.
3. Fasten the oil tank lid.
INSTALLING GUIDE BAR & SAW
CHAIN
1. Place the saw chain into the
groove and tip of the guide bar.
Check that the saw chain cutting
edge is in the appropriate
direction.
CAUTION:
Do not place the chain
on the guide bar in reverse
direction. If it is installed
incorrectly, the machine vibrates
severely and will cut poorly.
Assemble the front handle
1. Turn the clamp (c) to the front
handle (a).
2.Insert the front handle (a) on the
clamp (c) and adjust it to a
comfortable position.
3. Fixing the front handle by turning
the knob (b).
Telescopic tube height adjustment
1. Loosen the height adjustment knob
by turning it clockwise.
2. Pull out the telescopic tube to
desired length.
3. Turn the fixing knob counter-
clockwise to fasten the tube.
