3
1-800-348-5004
4.Turn the Engine Choke Lever
to its "CHOKE" position. Set the
Choke Lever in the "RUN"
position when starting a warm
Engine. (See Figure E.)
5.Then turn the Engine Power
Switch to its "ON" position. (See
Figure F.)
6.Grasp the Recoil Starter
Handle and pull slowly until
resistance is felt. While holding
the Handle, allow the Starter
Rope to rewind slowly. Then, pull
the Starter Handle with a rapid,
full arm stroke. Once again while
holding the Handle, allow the
Rope to rewind slowly. Repeat as
necessary, until the Engine
starts. (See Figure G.) warm up
for five minutes after starting with
no electrical load.
5. After the Engine starts and
warms up, slowly move the
Choke Lever to its "RUN"
position. (See Figure H.)
IMPORTANT: Allow the Engine
to run at
6. no load until warm (approx. 3
minutes) after each start-up to
allow the Engine to stabilize.
EQUIPMENT OPERATION
1.The total combined load
through the outlet on the
Generator must not exceed the
rated maximum power of the
unit.
2.Always reduce the load if the
AC Circuit Breaker turns off.
Once the load is reduced, press
the Breaker to reset the
Generator and continue
operation. (See Figure I.)
3.Allow the Engine to run at no
load until warm (approx. 3
minutes) after each start-up to
allow the Engine to stabilize.
4.To fill the Fuel Tank, first wipe
off the Fuel Tank Cap and the
surrounding area. (See Figure
C.)
5.Unscrew, and remove the Fuel
Tank Cap (See Figure C.)
6.Remove the Strainer and
remove any dirt and debris.
Then replace the Strainer. (See
Figure C.)
7.Fill the Fuel Tank to about 1
inch under the fill neck of the
Tank with the pre-mixed
unleaded gasoline/2-cycle oil
mixture.
8.Then replace the Fuel Tank
Cap (See Figure C.)
TO START THE ENGINE
1.Check to make sure the
Engine Switch is in its "OFF"
position.
2.IMPORTANT:Make sure to
unplug any load from the
Generator before starting to any
appliance, tool, or equipment.
3.Turn the Engine Fuel Switch to
its "ON" position. (See Figure D.)
"ON"
FIGURE D
Choke
Lever
"CHOKE"
"RUN"
FIGURE E
ON
FIGURE F
FIGURE G
Choke
Lever
"CHOKE"
"RUN"
FIGURE H
RESET
OFF
FIGURE I
CIRCUIT
BREAKER
