Nortel Web OS 10.0, Инструкция по применению

Страница: 209 / 482

Web OS 10.0 Application Guide
Chapter 8: Application Redirection
n
209
212777-A, February 2002
9. Create a default filter.
In this case, the default filter will allow all noncached traffic to proceed normally:
N
OTE
– When the
proto
parameter is not tcp or udp, then
sport
and
dport
are ignored.
10. Assign the filters to the client ports.
Assuming that the redirected clients are connected to physical switch Ports 5 and 6, both ports
are configured to use the previously created filters as follows:
11. Enable, apply, and verify the configuration.
N
OTE
– SLB must be turned on in order for application redirection to work properly. The
on
command is valid only if the optional Layer 4 software is enabled on your Web switch (see
“Activating Optional Software” in the Web OS Command Reference).
12. Examine the resulting information from the
cur
command. If any settings are incorrect,
make appropriate changes.
>> Filter 2# ../filt 224
(Select the default filter)
>> Filter 224# sip any
(From any source IP addresses)
>> Filter 224# dip any
(To any destination IP addresses)
>> Filter 224# proto any
(For any protocols)
>> Filter 224# action allow
(Set the action to allow traffic)
>> Filter 224# ena
(Enable the default filter)
>> Filter 224# ../port 5 (Select the SLB port 5)
>> SLB Port 5# add 2 (Add filter 1 to port 5)
>> SLB Port 5# add 224 (Add the default filter to port 5)
>> SLB Port 5# filt enable (Enable filtering for port 5)
>> SLB Port 5# ../port 6 (Select the SLB port 6)
>> SLB Port 6# add 2 (Add filter 1 to port 6)
>> SLB Port 6# add 224 (Add the default filter to port 6)
>> SLB Port 6# filt enable (Enable filtering for port 6)
>> SLB Port 6# /cfg/slb
(Select Server Load Balancing Menu)
>> Layer 4# on
(Activate Layer 4 software services)
>> Layer 4# apply
(Make your changes active)
>> Layer 4# cur
(View current settings)