Nortel 4500 Series, Обзор конфигурации системы

Страница: 172 / 320

172 Switch administration tasks
"ip address parameters" (page 172) describes the parameters for the
ip
address
command.
ip address parameters
Parameters Description
stack | switch | unit
Set the IP address and netmask of the stack or the
switch, or another unit in at a stack..
XXX.XXX.XXX.XXX Enter the IP address in dotted-decimal notation;
netmask is optional.
netmask The IP subnet mask for the stack or switch.
Note: When you change the IP address or subnet mask, connectivity to
Telnet and the Web can be lost.
no ip address command
The
no ip address
command clears the IP address and subnet mask for
a switch or a stack. This command sets the IP address and subnet mask for
a switch or a stack to all zeros (0).
The syntax for the
no ip address
command is
no ip address {stack | switch | unit}
Run the
no ip address
command in Global Configuration command
mode.
"no ip address parameters" (page 172) describes the parameters for this
command.
no ip address parameters
Parameters Description
stack | switch Zeroes out the stack IP address and subnet mask or
the switch IP address and subnet mask.
unit Zeroes out the IP address for the specified unit.
Note: When you change the IP address or subnet mask, connectivity to
Telnet and the Web Interface can be lost. Any new Telnet connection
can be disabled and must connect to the serial console port to configure
a new IP address.
ip default-gateway command
The
ip default-gateway
command sets the default IP gateway address
for a switch or a stack to use.
The syntax for the
ip default-gateway
command is
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.