Nortel 1001t, Руководство по установке, Страница: 79 / 124

Installing hardware 2-25
Adding a modem for Remote Access Service (RAS)
Standard 1.0 Nortel Symposium Call Center Server May 1998
1001t Hardware Installation Guide
Adding a modem for Remote Access Service (RAS)
Purpose
Follow this procedure to add a modem to the 1001t Server. This
modem is used for access to the server by a remote service PC.
Adding a modem
To add a modem to the 1001t Server, follow these steps.
Step Action
1 Make sure the AC cord is not plugged in.
2 Connect the large 25-pin male connector to the back of the
modem. Tighten the connector screws.
3 Connect the 9-pin female connector to COM port 1 at the rear
of the server. Tighten the connector screws.
4 Connect one end of the telephone cable to the modem RJ-11
jack labeled LINE.
5 Connect the other end of the telephone cable to the RJ-11
jack in the wall.
6 Connect the power cord to the modem and plug the other end
into a wall receptacle or power bar. Turn the modem on.