Doc No. 700016 Page 8 of 16
Using M4 setpins & washers fix the 'cut out'
end cap beneath the reflector profile at the burner
end with the
flanges facing outwards.
Locate M4 pins, washers & nuts into holes in
overlapping reflectors as shown.
1x 2x
2.5.4 End Caps
Using M4 setpins & washers fix the blank end
cap beneath the reflector profile at the U bend end
with the
flanges facing outwards
.
3x 3x
3x 3x
1x 2x
1x 2x
12
13
3x 3x
3x 3x
2x 2x
11
3x
3x
3x
3x
3x
2x
3x
3x
2.5.5 Canopies
Remove protective film before starting.
Slide the outer canopies over the reflectors from
the U bend end ensuring correct location in
reflector profile. Line up burner end canopy flush
with burner end reflector. Overlap canopies as
shown in the assembly diagram.
CAUTION — SHARP EDGES!
2x 3x
14
Adjust canopies so that the holes on top align
with each other as detailed in the assembly
instructions. Locate and fix one No.5 torque screw
on every canopy overlap.
1x 2x
15
4x
3x
Содержание Ambirad Vision VSX
Страница 13: ...Doc No 700016 Page 13 of 16 Figure 4 VSX Heater Breakdown 3 module shown...
Страница 14: ...Doc No 700016 Page 14 of 16 Notes...
Страница 15: ...Doc No 700016 Page 15 of 16 Notes...