Copyright ©
2019
Nortek Security & Control
36
GC2e Wireless Security System | User Guide
Wireless Keypad Emergency Keys
Each standard wireless keypad has Fire and Police
emergency buttons that can be enabled or disabled for
each keypad. Refer to the table below for options set for
your keypads:
Exit Delay Restart
The
Exit Delay
Restart option will extend the
Exit Delay
one
time if you need to re-enter the premises. When the system
is armed in the
Away mode
or
Stay mode
, the
Exit Delay
gives you time to leave without setting off the alarm. With
the
Exit Delay
Restart option, re-entering the premises after
you have left, but before the
Exit Delay
timer expires, will
restart the
Exit Delay
timer, giving you the full length of time
to leave again. The restart option only works once, each
time the system is armed.
● Off
● On
Cancel Display
A “cancel” message will be sent to the Central Station if the
system is disarmed within a preset period of time after an
alarm is triggered. The system can be set to display that a
cancel report was sent, or for higher security, the system
can be set not to display the cancel message.
● Off
● On
Cancel Time
To limit responses to false alarms, a “cancel” message will
be sent to the Central Station if the system is disarmed
within a preset period of time after an alarm is triggered.
The alarm report is always sent, but it will be followed by
a cancel report if you disarm the system within the preset
time.
This option helps the Central Station to determine whether
you accidentally caused the alarm or if the alarm was
caused by an intruder. It also lets the Central Station know
that you have returned to the premises. Even if a cancel
message is sent, the Central Station will verify the alarm
and possibly dispatch help. The cancel message may be
processed by the Central Station at a later time depending
on system programming.
● Five Minutes is the default, or _______ Minutes
Dialer Delay
If an alarm occurs, the system will delay dialing for a short
time to allow you to disarm the system in case the alarm
was accidentally tripped. The dialer delay reduces nuisance
traffic to the Central Station and can prevent receiving fines
that many cities impose when police respond to a false
alarm. Your installer also can program the system for no
dialer delay.
NOTE:
The dialer delay is also known as the abort window.
It gives you time to disarm, but doesn’t delay the siren from
sounding. Disarming during the abort window can display a
cancel message depending on the Cancel Display setting
(see "
Cancel Display
").
● 30 Seconds is the default, or ______ Seconds.
2-Way Voice
The system can connect with a Central Station operator
so they can converse with people on the premises after an
alarm. The 2-way voice option allows communication to
and from the Control Panel and the Central Station. 2-way
voice communications will occur after the system has made
its alarm report. Your installer sets which sensors can
trigger the 2-way voice option.
● Disabled
● Stay on line
● Stay on line, including fire and CO alarms.
Option
1 2 3 4
Emergency Keys Enabled
Emergency Keys Disabled
System Toolbox
