Copyright ©
2019
Nortek Security & Control
34
GC2e Wireless Security System | User Guide
INSTALLER PROGRAMMED OPTIONS
The installer can program different options to customize
the installation. The options listed below show the default
settings and a check box or area to denote custom settings.
Siren Run Time
If there is a burglary, panic (police), or emergency alarm,
the Control Panel sounds the siren for a preset time. After
the time expires, the siren will stop sounding. (Auxiliary
alarms run for an unlimited time.)
Four Minutes is the default, or the following:
8 Minutes
12 Minutes
16 Minutes
Unlimited
Sensor Trigger Limit
The system limits the number of times a sensor can re-
trigger an alarm while the system is armed. The setting is 1
to 6 times per sensor, per arming period.
Two Triggers is the default, or the following:
1 Trigger
3 Triggers
4 Triggers
5 Triggers
6 Triggers
Fire Horn Run Time
If there is a fire or carbon monoxide alarm, the Control
Panel sounds the fire alarm horn for a preset time. After the
time expires, the fire alarm horn will stop sounding.
Four Minutes is the default, or the following:
8 Minutes
12 Minutes
16 Minutes
Unlimited
Exit Delay
The
Exit Delay
begins immediately after arming the system.
The delay gives you time to leave through the designated
exit/entry door without setting off the alarm. During the
Exit
Delay
beeps sound, and faster beeps sound during the last
10 seconds.
NOTE:
Arming remotely does not start an
Exit Delay
.
● 60 Seconds is the default, or ________ For ________
Door.
Entry Delay
The
Entry Delay
begins when the designated entry/exit
door is opened while the system is armed. The delay gives
you time to disarm the system before triggering the alarm.
You must enter a valid
user code
on the Control Panel
or Wireless Keypad before the
Entry Delay
time expires.
During the
Entry Delay
, beeps sound to remind you to
disarm the system.
The system supports two different
Entry Delay
s:
● Entry Delay #1 is for your primary entrance door
● 30 Seconds is the default, or _________
Entry Delay
#2 is for a secondary entrance (such as a
garage door) and is usually set longer to give you time to
get to the keypad and disarm the system.
45 Seconds is the default, or _________ For ________
Door
24-Hour Emergency Functions
The system can be configured to display three 24-hour
emergency buttons on the Control Panel: Panic, Fire, and
Emergency. The installer can set which emergency buttons
on the Control Panel are active.
Panic (Audible)
Panic (Silent)
Fire
Emergency
