1
Copyright © 2018 Nortek Security & Control
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,2GIG-FT6 TEMP FLOOD SENSOR - P/N: 10021591 X4 - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 8.5000” X 11.000” - TOL. +/- 0.125”- SCALE: 1-1 - PAGE 1 OF 2- FOLDING: FOLD 4X TO FINAL SIZE: 2.125" X 2.750"- FINISH WITH LOGO SHOWING
2GIG-FT6-345
FLOOD AND TEMPERATURE DETECTOR
SENSOR
LITHIUM BATTERY
LITHIU
M
ALIGN DOTS
BATTERY TERMINAL
NEGATIVE (-)
BATTERY TERMINAL
POSITIVE (+)
BATTERY
PULL TAB
PULL ONL
Y
WHEN READ
Y
TO P
AIR
Replacing Battery
Open Sensor Case as shown in Figures 2 and 3.
Figure 2.
Opening the Sensor Case
Replacement Battery Installation:
NOTE:
If battery has been previously installed:
1. Remove battery, and dispose of properly (meeting state regulations).
2. Wait two (2) seconds.
3. Replace battery.
4. Close sensor.
INSTALLATION INSTRUCTIONS
The 2GIG-FT6-345 is a fully supervised, one-way 345 MHz sensor. It will monitor the
ambient temperature and/or will detect a wet/dry flood condition. The sensor reports
wet/dry conditions and temperature to the panel.
Flood Conditions
Once the sensor probe detects the presence of water, the integral transmitter will
immediately send a loop 3 wet alarm transmission to the panel. The probe will also
send a restore (dry) report when the presence of liquid is no longer detected. The
sensor is capable of detecting clean or dirty fresh water, salt water, or tap water.
The 2GIG-FT6-345 utilizes a unique design that can detect leaks dripping onto it’s
top or if there is water under the device. This dual sensing technology is perfect for
placement under P Traps or hoses that may leak, giving a warning just as the leak
starts. If a leak occurs at a different location as water is sensed under the device, it
will also send an alert.
Temperature Conditions
Heat:
1. If the temperature is more than 95° F (35°C) for three (3) minutes, the sensor will
send a loop 2 transmission.
2. If the temperature is less than 95°F (35°C) for three (3) minutes, the sensor will
send a loop 2 clear.
Cold:
1. If the temperature is less than 41°F (5°C) for three (3) minutes, the sensor will
send a loop 1 transmission.
2. In the temperature is more than 41°F (5°C) three (3) minutes, the sensor will
send a loop 1 clear.
Contents
Verify that the package includes the following:
• 1 — 2GIG Flood/Temperature Sensor
• 1 — 3V CR123A Lithium Battery
Figure 1.
Temperature/Flood
Sensor Contents
Grip the base of the sensor case. Turn the top cover counter-clockwise to align the
dots, then separate the sensor case.
Figure 3.
Installing New Battery
DETECTOR
WATER
Installing Temperature Sensor
The 2GIG-FT6-345 Flood and Temperature Sensor can be easily placed in any
location. If placed specifically under a potential leak source, use the included optional
double stick tape to secure it in the desired location (see
Figure 6
).
Figure 4.
Suggested Installation Locations
Place the sensor in locations
that have the potential of
water leaks or flooding.
For example:
• Under the sink pipes
• Adjacent to water heaters
• Adjacent to toilets
• Adjacent to bathtubs or
showers
• Under or near your
dishwasher
• Near washer and dryer
