7
8
3a
3b
4
5
Test cable
terminals
Reattaching the Camera Module
3a.
Reinsert camera module into
camera base by aligning the arrow
notches on the edge of the camera
module and the camera base
(label on edge of camera module
indicates the location of the arrow
notch), and turning camera
module clockwise to lock into
place.
3b.
Use the 3 base locking screws
to secure camera base to camera
module.
Go to step 4 to complete
installation.
4.
Remove camera cover by
squeezing the back and front of
the cover (as indicated by the
arrow indicators) at the same
time and lifting it up and away
from the lens.
5.
Insert a video test cable into
the video test cable terminals
and connect to a test monitor to
set up camera.
Video Test Cable
6a
Thumb Screw
6b
6c
microSD card
6a.
Adjust camera viewing angle and secure into
place by tightening thumb screw using a flat head
screwdriver.
Avoid pointing the camera lens in
angles where the IR LEDs are
blocked by the camera cover or dome
cover. If IR LEDs are blocked, it may
result in an unclear nighttime image.
6b.
Adjust zoom and focus as required.
NOTE:
Lens adjustment levers are by default
in the locked position. Turn counterclockwise
to unlock. Tighten levers to secure lens
setting.
6c.
(Optional) Insert a microSD card into the
camera. To enable recording, you must
format the microSD card and configure
microSD recording (see “8.9.1 Record
Directory” on page 43).
NOTE:
The camera supports microSD cards
up to a maximum size of 64GB. SanDisk™ or
Kingston™ brand microSD cards are
recommended.
6d.
Re-attach the camera cover, using the
thumb screw as a guide, until it snaps into
place.
