NORSELIGHT 7070404023366, Руководство пользователя

Страница: 17 / 40

6500201 Rev - SH R50
17
Note: If the lamp is not removed when these symptoms appears, it might cause damaging of other
components.
USE eyeprotection!
Procedure:
1. Cut the main power to the searchlight.
2. Before replacing the lamp, disconnect the luminaire from the power supply.
3. Make sure the lamp has cooled down, before opening the lamphouse (approx. 10 min).
4. To replace an old lamp, first disconnect the cable lugs and then remove the ceramic stop. The
lamp can then be removed.
5. Install the lamp in reverse order. Hold the new lamp only in by its ceramic surfaces or power supply leads.
Note: Do not touch the bulb with bare hands or anything greasy!
Be careful not to damaged any parts.
If the bulb is dirty the quartz surfaces should be cleaned with a soft cloth soaked in spirit. Do not
scratch the bulb or place it where it can be in touch with water as there is a danger that it will
explode.
General Searchlight Maintenance
Performed at intervals not exceeding 6 months:
• Control of all gaskets and cable glands.
• Control of all screw and nut connections.
• Check lampholder with contact points.
• Reflector and front glass to be cleaned with a soft cloth and alcohol.
•
Tighten all terminals strips in the searchlight junctionbox.
•
Check the level of grease an refill when needed in glider for lamp holder.
•
Check the level of grease and refill when needed underneath the VS120 gasket on the top of the motorhousing.