NORSELIGHT 7070404023366, Руководство пользователя

Страница: 15 / 40

6500201 Rev - SH R50
15
3 Installation
Mechanical installation
•
The searchlight must be mounted on a horizontal surface using 4 stainless screws.
•
The Main/Slave Operation Panel and the Switch is designed for installation in indoor applications.
•
The Access Point is designed for out side installation.
Electric installation
•
The Main Operation Panel requires 24V DC connected in series with a 1A fuse to the positive (+) conductor.
•
The Switch requires 24V DC. In addition to grounding
•
Depending on The Searchlight model, it requires 24VDC, 115VAC or 230VAC.
Note: Disconnect the power when working on the equipment!
Electrical equipment must be installed by authorised personnel!
Check the polarity when connection of 24VDC!
All Searchlight system equipment MUST BE connected to ground/earth!
BUS installation
•
The BUS communication system requires minimum LAN CAT5e, 4 pair shielded twisted pair cable.
•
All connection entries need RJ45 connector using T-568B cable standard.
•
Make sure that all cable entries maintain their shield protection.
Note: Follow the installation requirements from your cable supplier!
Avoid brakeage on the Ethernet connectors (panel, switch and searchlight COM-
module)!
Start up procedure
•
Powering up. By powering up the SCS R50 Searchlight system, the panel indicate splashing
figure in LED display of the Operating Panel. The system starts to search for all units
connected to the system. After few seconds a specific number of the searchlight in
contact, will appear in the LED display.
•
Position Calibration Turn the searchlight to Starboard side by using the Joystick turning non stop until T
appears in LED-indication of the Main Operation Panel. Then turn to Port side non
stop to the end position until T appears in LED-indication. Now the searchlight
position indication will follow the movement of the searchlight 360
o
.
4 Operation
Operation Panels function
LED-indication display:
•
Searchlight number in use