21
PULSE PRO User Manual
Electromagnetic Compatibility
The information contained in this section (such as separation distances) is in general specifically written
with regard to the NormaTec PULSE PRO. The numbers provided will not guarantee faultless operation
but should provide reasonable assurance of such. This information may not be applicable to other
medical electrical equipment; older equipment may be particularly susceptible to interference.
GENERAL NOTES
Medical electrical equipment requires special precautions regarding electromagnetic compatibility
(EMC) and needs to be installed and put into service according to the EMC information provided in this
document and the remainder of the instructions for use this device.
Portable and mobile RF communications equipment can affect medical electrical equipment.
Cables and accessories not specified within the instructions for use are not authorized. Using
other cables and/or accessories may adversely impact safety, performance and electromagnetic
compatibility (increased emission and decreased immunity).
Care should be taken if the equipment is used adjacent to or stacked with other equipment; if adjacent
or stacked use is inevitable, the equipment should be observed to verify normal operation in the
configuration in which it will be used.
ELECTROMAGNETIC EMISSIONS
This equipment is intended for use in the electromagnetic environment specified below. The user of
this equipment should assure that is used in such an environment.
EMISSIONS
COMPLIANCE
ACCORDING TO
ELECTROMAGNETIC ENVIRONMENT
RF emissions
(CISPR 11)
Group
1
The equipment uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in
nearby electronic equipment.
CISPR Emissions
Classification
Class B
The equipment is suitable for use in all
establishments including domestic establishments
and those directly connected to the public low-
voltage power supply network that supplies
buildings used for domestic purposes.
Harmonic emissions
(IEC 61000-3-2)
Class A
Voltage fluctuations/
flicker
(IEC 61000-3-3)
Complies
ELECTROMAGNETIC COMPATIBILITY
