7. Remote initial setup
Note: When power is first connected to the multi-unit system (system
controller and units), the remote enters an initial setting mode.
The following instructions explain how to perform an initial setting.
If you need to change these settings at a future date, follow the
instructions titled System Selection and Settings in the “Initial
Settings” Screen (page 11 - 13).
Initial Setting Procedure in the “System Settings” Screen
1
2
3
Preparation
Press the
button on the remote.
Operation
Screen Display
Description
Connect power to all heaters and system controller
in multi-unit system.
1) You will be prompted to choose
a system type.
2) Use the
buttons to navigate
to the correct system type.
(Standard, Recirc., or Tank Recirc.)
3) Press the
button to
select your system type.
1) If you chose the “Recirc.” or
“Tank Recirc.” systems, you
will be prompted to turn pump
rotation on or off (this setting
is set to “off” by default).
2) Use the
buttons to select
yes (on) or no (off).
3) Press the
button to set
the pump rotation.
4
1) You will now be prompted to
“complete system setting.”
2) Press the
button to
complete the system setting.
3) Once you choose “Complete
system settings?”, the
remote will display “System
settings completed”.
* Note: if you chose standard system in
step 2 - 2), you will immediately go to
this prompt.
* You may use the
button to
return to the previous menu at any
time.
* Note: only when you connect one/two
pumps to the system controller, you
need to select “Yes” or “No”.
─10─