Noritz EZ2FVK-2, Руководство по установке, Страница: 12 / 24

12
Step Installation Procedure(ex. @Garage) Necessary Tool
6 Push the
" ⑮ Flex Feeder" into the tip of the " ③ Flex Pipe 2"" .
③ Flex Pipe 2"
⑮ Flex Feeder
7 Insert the " ③ Flex Pipe 2"" into the " ⑥ Base Junction Support" until you touch the
inside of the rain cap on the roof.
With the " ③ Flex Pipe 2"" fully inserted into the vent, make a mark at the " ⑥ Base
Junction Support" so you can check for movement during the rest of installation.
Marker
Step-1
(W
ork where equipment is installed)
Install the "
⑮
Flex Feeder" always, even in the case of straight B-Vent runs.
( "
⑮
Flex Feeder" prevents debris from falling into the "
③
Flex Pipe 2"" .)
Be sure to do
When pushing "
③
Flex Pipe 2"" through the B-Vent, if there is unusual feeling
(touching the bump of screw, etc.), do not continue to push in and stop the installation.
Be sure to do
Do not use the "
③
Flex Pipe 2"" at any jobsite with vent runs longer than 35', do
not join two shorter flex pipes together even if the run is less than 35'.
Prohibited
[Point]
Before inserting, try to straighten curl of the tip of " ③ Flex Pipe 2"" as much as possible.
However, when doing so, bending radius should be more than 7 inch.
[Point]
Continue to push " ③ Flex Pipe 2"" strongly until the end and make sure that it does not
stop in the middle.
r>7 inch