10
(e.g. 110°F)
(e.g. 105°F)
2. Set the temperature using the / buttons.
1. The button is ON.
Operation
• The POWER indicator is displayed.
• The previously set hot water supply
temperature is shown.
Temperature Setting Options
The temperature settings below are examples.
The temperature setting necessary depends on the usage,
the length of piping and the season.
[When using °F mode]
(Default setting is 110°F)
[When using °C mode]
(Default setting is 40°C (104°F))
100°F
Washing dishes, etc.
105°F
Shower, hot water supply, etc.
110°F
115°F
120°F
125°F
High temperature*
(The maximum output temperature
can be set using the Remote
Controller. (See page 11))
130°F
135°F
140°F
37°C
(99°F)
Washing dishes, etc.
38°C (100°F)
39°C (102°F)
Shower, hot water supply, etc.
40°C (104°F)
41°C (106°F)
42°C (108°F)
43°C (109°F)
44°C (111°F)
45°C (113°F)
46°C (115°F)
47°C (117°F)
48°C (118°F)
50°C (122°F)
55°C (131°F)
High temperature*
(The maximum output temperature
can be set using the Remote
Controller. (See page 11))
60°C (140°F)
* Display when high temperature is set
(e.g. 125°F)
Setting Hot Water Temperature
NOTE
• Hot water temperatures shown
are approximate and may differ
from the actual temperature at
the fixture depending on external
factors such as the season and
length of piping in the system.
• When low temperatures are set
(for washing dishes, etc.), if the
incoming water temperature
is already quite high, it may be
difficult to ensure the outgoing
water temperature is as per the
setting.
• Check the temperature displayed
before using any hot water.
Be especially careful using hot
water after the set temperature
has been changed.
• When the hot water temperature
is adjusted using thermostatic
water mixing valves, set the
temperature on the Remote
Controller approximately 20°F
(10°C) higher than the required
temperature to ensure the
appropriate fixture temperature.
• For most residential applications,
the recommended setting
temperature is 120°F (50°C in °C
mode) or less.
NOTE
• Consult local codes for minimum
operating temperatures.
• Noritz recommends that water
temperature is set as low as
possible to prevent scale build-up
in the Heat Exchanger.
PRIORITY indicator is displayed.
Blink for 10 seconds
Setting Hot Water Temperature
Содержание EZ111
Страница 24: ......