Nordson Sure Coat Series, Руководство пользователя по изделию

Страница: 47 / 66

Repair
6-1
2001 Nordson Corporation
All rights reserved
334 627B
Issued 3/01
Manual 31-46
Section 6
Repair
WARNING: Allow only qualified personnel to perform the
following tasks. Follow the safety instructions in this document
and all other related documentation.
WARNING: Turn off the electrostaic voltage and ground the
gun electrode before performing the following tasks. Failure to
observe this warning could result in a severe shock.
WARNING: System pressurized. Relieve system pressure
before servicing. Failure to observe this warning may result in
personal injury or death.
Use the following procedures to remove the gun from the mounting
assembly.
NOTE: Refer to Mounting in the Installation section for instructions for
installing the gun and mounting assembly after repairs.
See Figure 6-1.
1. Unscrew the inlet connector nut (6) and pull the inlet
connector/powder feed hose assembly (5) from the inlet connector
body (4).
2. Disconnect the gun cable from the gun cable extension (8).
3. Disconnect the gun air tubing from the gun air coupling (7).
4. Loosen the handle (2). Remove the gun and gun bar clamp (3)
assembly and take them to a clean work area to perform any repair
procedures.
1. Removal from the Gun
Mount