Nordson FoamMelt 200, Руководство по эксплуатации продукта

Страница: 18 / 306

Safety
A 1-4
E
2015 Nordson Corporation
All rights reserved
321222_06
Issued 04/2015
A1EN − 02 − [XX − SAFE] − 1
WARNING: Failure to follow the safety procedures can result in
injury or death.
S
All electrical, pneumatic, gas, and hydraulic connections and
installations of hot melt equipment may only be carried out by
qualified personnel. Be sure to observe installation instructions for
components and accessories.
S
Equipment must be properly grounded and fused according to its
rated current consumption (see ID plate).
S
Cables which run outside the unit must regularly be checked for wear
or damage.
S
Power supply wire gauge and insulation must be sufficient to handle
rated current consumption.
S
Cables must never be squeezed or pinched. Do not locate cables or
hoses in high traffic areas.
The unit should be operated by qualified personnel in accordance with
the instructions presented in this document.
WARNING: Failure to follow the safety procedures can result in
injury or death.
S
Never allow the unit to be operated by personnel under the influence
of substances which reduce their reaction times, or who are not able
to operate the equipment for physical reasons.
S
Prior to each start-up of the unit, check protection and warning
devices and make sure they are fully functional. Do not operate the
unit if these devices are not functioning properly.
S
When the removal of safety equipment is required for installation,
maintenance, or repair of the unit, it must be re-connected
immediately upon completion of the work.
S
Prior to start-up of the unit, check to make sure all safety guards and
safety equipment are in place and functioning properly.
5. Installation and
Electrical Connections
6. Operation