Nordson AltaBlueA4TP, Руководство пользователя по изделию

Страница: 100 / 276

Operation
4-26
Part 1107600_03 2014 Nordson Corporation
Adjusting Component Temperatures
(contd)
To adjust the setpoint temperature of an individual component
1. Press and hold the Tank , Hose , or Gun key for three seconds.
If the tank key was pressed, the left display indicates 1 (Flashing). If a
hose or gun key was pressed, the left display indicates the number of the
first sequential hose or gun (Flashing). The right display indicates the
current setpoint temperature of the component indicated in the left
display.
2. Scroll the left display to the number of the desired component.
The right display indicates the current setpoint temperature of the
component that you selected in the left display.
3. Press the Enter key.
The right display flashes.
4. Use the keypad to enter the setpoint temperature recommended by
the manufacturer of the hot melt. Refer to the technical data
sheet provided by the manufacturer of the hot melt to determine the
optimal setpoint temperature.
NOTE: If the keypad or the right‐display scroll keys have no affect on the
right display, the melter is password protected. You must enter a valid
password before you can change setpoint temperatures. Refer to
Entering the Melter Password later in this section.
5. Do one of the following:
To register the new setpoint temperature and then move on to change
the setpoint temperature of the next sequential component, press the
Enter key and then repeat steps 4 and 5.
To register the new setpoint temperature and return to the automatic
scan mode, go to step 6.
6. Press any component key (tank, hose, or gun).
The selected component begins to heat or cool to its new
setpoint temperature.