Nordmann Engineering SPA Display, Инструкция по установке и эксплуатации

Страница: 10 / 36

10
4.3 Notes on positioning the Nordmann SPA Displays
Please observe the following notes for the correct positioning of the Nordmann SPA Display(s):
– The Nordmann SPA Display(s) must not be installed in hazardous locations and in rooms where
water splashes may occur.
– Do not mount the Nordmann SPA Display(s) inside the steam bath cabin, sauna, bio sauna, etc..
– If possible mount the Nordmann SPA Display(s) at eye level.
– Do not mount the Nordmann SPA Display(s) in exposed places.
– Do not mount the Nordmann SPA Display(s) on vibrating components.
– Place the Nordmann SPA Display(s) in such a way, that the total length of 50 m of the CAN BUS
cables with which the Nordmann Omega or the Condair Delta SPA Control Box and the Nordmann
SPA Display(s) are interconnected is not exceeded.
4.4 Mounting the Nordmann SPA Display
CAUTION!
The electronic components of the Nordmann SPA Display are very sensitive to electrostatic discharge.
For all installation work on equipment appropriate measures must be taken to protect these components
against damage caused by electrostatic discharge (ESD protection).
Note: the Nordmann Omega or the Condair Delta SPA Control Box, respectively and the Nordmann SPA
Display(s) (up to a max. of 8 SPA Displays) are interconnected via a so-called CAN BUS. Use only a
shielded four-wire cable with a cross section of 0.34 mm
2
per wire to establish the CAN BUS con-
nections. The total length of the CAN BUS must not exceed 50 m .