Other features
Turns on when the bucket is ready to be
emptied, or when the bucket is removed
or not in the proper position.
8
Display
Shows the set % humidity level from 35% to 85% or auto start/stop time (0~24) while setting,
±
5% accuracy) room % humidity level in a range of 30% RH (relative
Error Codes and Protection Codes
AS- Humidity sensor error--Unplug the unit and plug it back in. If error repeats, call for service.
ES- Temperature sensor error--U
nplug t he u nit a nd p lug i t b ack i n.If e rror r epeats, ca ll fo r se rvice.
P2- Bucket is full or bucket is not in correct position-- Empty the bucket and replace it in the right
position.
CONTROL PADS ON THE DEHUMIDIFIER
Bucket Full Light
Auto Shut Off
Auto Defrost
when frost builds up on the evaporator coils. The
compressor will cycle off and the fan will continue
to run until the frost disappears, then the light will
turn off.
seconds when the bucket is full, or when the
bucket is removed or not in the proper
position. When the humidity setting is reached,
the unit will shut off automatically. For some
models, the fan motor will continue operating
then shows the actual (
When the unit is on, first press the Timer
pad. The Off indicator light
comes on, indicating that the Auto Stop
program has started. Press the Timer pad again.
The Timer On indicator light turns on, indicating
that Auto Start has begun.
When the unit is off, first press the Timer
pad. The Timer ON indicator light
comes on, indicating that the Auto Start
program has started. Press the pad again. The
Timer Off indicator light turns on, indicating
that Auto Stop has begun
Press or hold the UP or DOWN pad to
change the Auto time in 0.5 hour incre-
ments up to 10 hours, then in 1 hour
increments up to 24 hours. The system
counts down the time remaining until
start.
The selected time will register in 5 seconds
and the system will automatically revert
back to display the previous humidity
setting.
When the Auto Start & Auto Stop times are
set, within the same program sequence,
The TIMER ON/OFF indicator lights illuminate,
indicating that both the ON and OFF times are
now programmed.
Turning the unit ON or OFF at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop function.
When the LED display window displays the P2 code,
the
cancelled.
Auto Start/Stop function will also be
Setting the Timer
Wait 3 minutes before resuming operation
Check Filter Feature
Auto Restart (on some models)
when the power resumes.
The system starts to count the time once the fan
motor turns on. The Check Filter feature can only be
activated when the accumulated operation time reaches
250 hours or more.
The Clean Filter indicator light
flashes once per second. After cleaning the air
filter, press the Filter pad and the Clean Filter indicator
light will turn off.
in the first 3 minutes. This feature protects
the unit. Operation will automatically start after
3 minutes.
After the unit has stopped, it cannot restart
humidity) to 90% RH.
5
The dehumidifier shuts off completely after 30
The Auto Defrost indicator light will illuminate
If the unit stops unexpectedly due to a loss of power,
it will restart automatically with its previous settings
