14
TROUBLESHOOTING AND MAINTENANCE
Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immedi-
ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
10
31
30
6
51
27
40
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the cables before resistance is felt,
the cables should be tightened. Make sure that the
cables are not too tight, or the top weight will be lifted
off the weight stack.
Slack can be removed from the cables by moving the
3 1/2” Pulley (27) to a higher set of holes in the
bracket on the Hack Squat Top Frame (6). Remove
the M10 Nylon Locknut (51) and the M10 x 46mm
Button Head Bolt (40) from the Pulley and Top Frame
bracket. Re-attach the Pulley with the Bolt and
Locknut.
Additional Slack can be removed by tightening the
Medium and Short Cables (30, 31) into the
Counterweight (10).
Note: If a cable tends to slip off the pulleys often,
the cable may have become twisted. Remove the
cable and re-install it.
If the cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this
manual.
