Nordic R-09, Инструкция по установке и обслуживанию

Страница: 29 / 60

11-May-2021 Page 29 002512MAN-01
Startup Record: R-Series Size 09-24 R410a
Installation Site
Startup Date Installer
City Company
Province Model
Country Serial #
Customer Name Customer Phone #
Check boxes unless asked to record data. Circle data units.
PRE-START INSPECTION
Ductwork Ductwork is completed, dampers/ diverters are adjusted
Registers are open and clear of objects
Air filter and end cap are installed
Condensate Drain is connected, properly vented and free of debris
Plenum heater is securely fastened (if applicable)
Ground Loop
System
All shut-off valve are open (full flow available)
Loop is full and purged of air
Antifreeze type
Antifreeze concentration % Volume % Weight
Loop static pressure psi kPa
Ground Water Water Valve installed in return line
System
Flow control installed in return line
Electrical High voltage connections are correct and securely fastened
Circuit breaker (or fuse) size and wire gauge for Heat Pump A Ga.
Circuit breaker (or fuse) size, wire gauge, and Plenum Heater size A Ga.
kW
Low voltage connections are correct and securely fastened
STARTUP DATA
Preparation Voltage across L1 and L2, L1 and L3, L2 and L3 VAC
Heating Mode Suction Pressure / Discharge Pressure psi kPa
(10 minutes)
Duct Return, Duct Supply, and Delta T In Out °F °C
Outdoor In (Supply In), Outdoor Out (Supply Out), and Delta T In Out °F °C
Outdoor Flow Igpm gpm L/s
Compressor L1 (black wire) current A
Thermostat setpoint, suction and discharge pressures at cycle end °F
°C psi kPa
Cooling Mode Suction Pressure / Discharge Pressure psig kPa
(10 minutes)
Duct Return, Indoor Out, and Delta T In Out °F °C
Outdoor In (Supply In), Outdoor Out (Supply Out), and Delta T In Out °F °C
Thermostat setpoint, suction and discharge pressures at cycle end °F °C psi kPa
Date: Installer Signature: Customer Signature:
A total of three copies are required: one for the homeowner, one for the installer and on to be sent to Maritime Geothermal Ltd.