Nordic POBA2600, Руководство по эксплуатации, Страница: 9 / 12

9
NORDIC
• Simple wheel change by spindle lock:
• Press the spindle lock and allow the grinding wheel to latch in place.
• Open the flange nut with the face spanner. (Fig. 6)
• Change the grinding or cutting wheel and tighten the flange nut with the face spanner.
Only ever press the spindle lock when the motor and grinding spindle are at a standstill! You must keep
the spindle lock pressed while you change the wheel!
For grinding or cutting wheels up to approx. 3 mm thick, screw on the flange nut with the flat side facing
the grinding or cutting wheel.
8.5 FLANGE ARRANGEMENTS WHEN USING GRINDING WHEELS AND CUTTING WHEELS
(FIG. 7-10)
• Flange arrangement when using a depressed-centre or straight grinding wheel (Fig. 8)
a. Clamping flange
b. Flange nut
• Flange arrangement when using a depressed-centre cutting wheel (Fig. 9)
a. Clamping flange
b. Flange nut
• Flange arrangement when using a straight cutting wheel (Fig. 10)
a. Clamping flange
b. Flange nut
8.6 MOTOR
It is vital for the motor to be well ventilated during operation. Be sure, therefore, to keep the ventilation
holes clean at all times.
8.7 GRINDING WHEELS
• Never use a grinding or cutting wheel bigger than the specified diameter.
• Before using a grinding or cutting wheel, check its rated speed.
• The maximum speed of the grinding or cutting wheel used must be higher than the idle speed of the angle grinder.
• Use only grinding and cutting wheels that are approved for a minimum speed of 7,000 rpm.
• Check the direction of rotation when you use diamond cutting wheels. The directional arrow on the diamond cutting
wheel must point in the direction in which the tool rotates.
Take special care that the grinding/sanding wheels are properly stored and transported. Ensure that the
grinding/sanding wheels are never exposed to shock, jolts or sharp edges (for example during transport or
