Features
Each function is confirmed with a short vibration.
Stand-by mode
When Ping™ 6 is turned on, it enters into
stand-by mode. While in the stand-by mode, the
device is not activated on any process but is
ready to receive and answer location requests.
Stand-by mode is left when another mode is
activated.
Positioning
Positioning is activated by sending PING a
?LOC message from a mobile phone or a
back end system supporting MPTP protocol.
An INF message with position, time, speed
and direction will be received. Positioning can
also be activated by sending PING a NRPOS
message you will then receive the same
message but more readable in a phone display.
Vibration
Three short vibrations is activated by sending
PING a NRVIB SMS from a mobile phone or a
back end system supporting MPTP protocol.
Anchor
Anchor mode can be used to anchor Ping™ 6 to
a defined position. In anchor mode, Ping™ 6
is continuously calculating it’s position and
comparing it with the position it had when the
anchor mode was entered.
Anchor mode is switched to alarm mode if
Ping™ 6 moves further than allowed from
it’s original position. You can set the alarm
triggering distance by defining maximum
allowed movements in configuration. For
more information, see Config 15: Max allowed
movement in anchor mode.
By sending a SMS command NRAON to the
Ping™ 6 the anchor mode can be activated
and it can be deactivated with the command
NRAOF.
The anchor mode can also be activated by
pressing and holding down the anchor button for
about 5 seconds. You can deactivate the mode
by pressing the anchor button again. Anchor
mode can be activated simultaneously with
tracking and alarm modes.
Содержание Ping 6
Страница 1: ... Ping 6 User manual ...
Страница 13: ...13 ...