Reset to Factory Default:
To reset to factory default, power off, press the Exit Button hold it and power on,
there will be two beeps, and the LED light turns yellow. Release the exit button,
then read any two 125KHz EM card/13.56MHz Mifare cards, the LED will turn red,
indicating the reset to factory default was successful. Of the two cards reading, the
1st one is Master Add card, the 2nd one is the Master Delete card. Remarks: Reset
to factory default, the users' information is still retained
Erase all Cards
*Master Code # 2 Master Code #*
This will delete ALL User data, but all configuration data is retained.
Master Cards Using
Using Master Crds to add and delete card users
Add a User Card
Read Master Add Card
Read User Card
Repeat Step 2 for additional user cards
(
Read Master Add Card
)
Delete a User Card
Read Master Delete Card
Read User Card
Repeat Step 2 for additional user cards
(
Read Master Delete Card
)
Operation Status
Stand By
Enter into programming
mode
Red Light bright
Red Light shines
LED
In the programming
mode
Yellow light bright
Operation error
-
Sound and Light Indication
-
One beep
Buzzer
Three beeps
One beep
10
www.nordencommunication.com
