Norco BIS-6592LC, Руководство пользователя, Страница: 31 / 83

BIS-6592LC
LED Screen Control Hardware Platform supporting 1080PHD Display
24
2
）
HDDLED Pins (J4 pin3,pin4 for HDD LED)
As a rule, there is a HD LED on the panel of chassis, while HD device (like hard Disk) is
reading or writing (no matter which HD device), LED will flash, shows that IDE device is
running. Connect IDE LED on chassis panel and these pins (pin3 is LED anode)
3
）
Reset Button Pins(pin7,pin8 for RESET )
Connect this pins and RESET switch on panel of chassis with cable. When system can not
work on, reset can make system restart, without turning on/off the power, thereby it can
prolong system lifespan.
4
）
Power On/Off Control Pins (pin9, pin10 for POWER BUTTON)
Connect these two pins with bounce switch on panel of chassis, to switch-on or switch-off the
power.
2.6.14 SO-DIMM
（
SO-DIMM1, SO-DIMM2
）
Board front panel and rear panel with 1x 204PIN DDRIII DIMM slot respectively support DDRIII
800/1066MHz RAM upto 4GB.
2.6.15 PCIE Slot
MITX-6892 provides 1x standard PCIE slot to connect other external devices.
2.6.16 Mini PCIE
（
MINI_PCIE1, MINI_PCIE2,J3,J4
）
Board rear panel and front panel with 1x Mini PCIE slot respectively. Customer can select
suitable mini PCIE device. If customer use Mini PCIE wireless LAN, which can shows WIFI
network card status by they selected wireless network .PIN 1 and PIN 2 is WWAN
（
wireless
wide area network
）
, PIN 3 and PIN 4 is WPAN.
J3/J4 :
Signal Name Pin Signal Name
LED_WWAN# 1 2 VCC3.3SB
LED_WPAN# 3 4 VCC3.3SB