- 10 -
CAUTION
: When installing the camera outdoors, the following instructions
must be followed closely.
1. Loosen the four torx screws located midway up the front of the housing. Leave
the screws intact in the front portion.
2. Drill the mounting location, using the bottom of the housing as a template.
BASE INSTALLATION (VVRDF4V9)
3. Use silicone sealant around the rubber grommet to protect it against water intrusion.
4. Before closing the housing, take off the protective nylon and insert the supplied
desiccant bag.
Note:
Silicone sealant is not supplied.
The housing can also be mounted
on a 4s electrical box.
MOUNTING HOUSING TO ELECTRICAL BOX
Torx
screws (4x)
M4X8 pan head
screws (2x)
Wall / Ceiling
Rubber
washer
FC1 M4X20 flat head
screws (4x)
M4 plastic
anchors (4x)
M4x8 Pan Head
Screws (4x)
8-32 X 0.75
Flat Head
Screws (2x)
Rubber
Washers (4x)
