NORAUTO 872503, Руководство пользователя

Страница: 95 / 153

94
SWC mode
Built-in SWC Interface
The built-in SWC interface is compatible with
most vehicles equipped with “resistive type”
OE steering wheels.
Note:
Not all OE steering wheel functions may be
supported by the unit.
The following controls are available for most
vehicles:
To access the SWC Controls for programing,
touch the Steering Wheel icon on the second
page of the Main Source Menu.
SWC Programing
Up to 12 steering wheel control functions
can be programmed via the built-in SWC
interface. Not all functions may be supported
for each vehicle.
1. Popular OE steering wheel functions are
already preprogrammed from the factory.
If your vehicle does not support the exact
same functions already preprogrammed,
you will need to clear / reset the SWC
interface and program in the exact
functions of your vehicle. To clear / reset
the SWC interface, press and hold “Reset”
for 2 seconds.
2. To begin programming the SWC interface
after it has been cleared / reset, press a
number 1 ~ 12, then press a function. A
check mark should appear corresponding
to the number and function. Continue
programming in this manner until all of the
OE steering wheel control functions are
completed.
Note:
Functions 1 ~ 12 must be assigned to a
function on the OE steering wheel. For
example, if the OE steering wheel does not
support and Preset -, then these
functions must be cleared / reset in order
for the other functions to work correctly.
3. To “learn” the programming completed
in step 2 above, press the “Program”
button. You will then be prompted to push
each button on the OE steering wheel
(for 1 second), so the unit can learn the
corresponding function.
4. SWC learning / programming is now
complete.
1. Volume
Up (+)
4. Seek Up
(Next)
7. Preset (+) 10. Answer
2. Volume
Down (-)
5. Seek
Down (Prev)
8. Preset (-) 11.BT Send
3. Mute 6. Source 9. Band 12.BT End