19
Figure 23 – Cable Configurations: C10, C02 and C03
8.
Connect the 6-pin Tower on the Valve
Cable (
C03
) to the mating 6-pin Shroud on
C10
at the rear of the sprayer and route to
the NORAC valve block (
Figure 23
).
19.
The connectors on the valve cable (
C03
)
are marked
RIGHT UP
,
LEFT UP
,
RIGHT DOWN
and
LEFT DOWN
.
Cables labeled with
UP
go on the same side
as the hydraulic hoses.
Figure 24 – Valve Cable Connections
20.
Connect the sensor branch cable (
C02
) to
the 4-pin AMP plug on
C10
.
21.
Route the long branches of the sensor
branch cable (
C02
) to the wing sensors and
connect. Follow existing cables and/or
hydraulic lines along the boom.
22.
Route the short branch of cable C02 to the
roll sensor and connect.
23.
Cable-tie the installed cables every 12
inches.
IMPORTANT:
Provide enough slack in all cables to
account for the movement of the main
section, parallel lift, and FOLDING boom
movement.
