Norac UC4 Plus Rogator 1286C, Руководство по установке

Страница: 27 / 36

24
Figure 25 – Cable Configurations: C11, C12 and C03
10. Route C11 to the rear of the sprayer, in
the vicinity of the valve block.
11. Connect the Interface cable (
C12
) to the
mating connector on C11 ( Figure 25 ).
12. Route the free end of C12 to the Rogator
valve block.
13. Tee the Deutsch connectors into the
connectors on the sprayer solenoids. To
tee in, unplug the existing connector
from the solenoid and insert the NORAC
plug. Connect the Rogator plug that was
disconnected, to the receptacle end of
the tee on the NORAC cable. The
cables to be teed in are shown in Table
7.
One of the tees marked “MAIN
UP” will not be used.
Table 7 - Rogator and NORAC Valve
Labels
Rogator Label NORAC Label
LH FOLD UP LEFT UP
LH FOLD DN LEFT DN
RH FOLD UP RIGHT UP
RH FOLD DN RIGHT DN
HOIST UP MAIN UP
HOIST DN MAIN DN
14. Connect the 6-pin Tower on the valve
cable (
C03
) to the mating connector on
C10 ( Figure 25 ).