Norac UC4 Plus Rogator 1286C, Руководство по установке

Страница: 23 / 36

20
44963D
44933D
Figure 20 – Valve Block Assembly
4.6.2 Valve Mounting
1.
Mount the NORAC valve (
V01
) on the
sprayer using the valve mounting
bracket (
B10 ).
2. As shown in Figure 21 , screw short side
of the threaded rods into the bottom of
the valve block at least 3/8". The valve
mounting holes are drilled and tapped
3/8 NC-1" deep.
3. Tighten the Hex nuts to hold the rods.
4. Put the mounting bracket on the other
side of the tube and tighten with the
spring washers and the Hex nuts. Cut
excess off of the rods, if necessary.
If using bolts, the bolts should
thread into the valve block at least
3/8". The valve mounting holes
are drilled and tapped 3/8 NC-1"
deep. The rule of thumb for bolt
length is 1-1/2" longer than the
tube size.
You must ensure no hydraulic
components will interfere with any
sprayer parts or be pulled tight at
any time.
Figure 21 – Valve Mounting Location