21
EN
1. Mount the wall mount on the wall
with screws (4* 45 mm) and rawlplugs
(drawing A).
2. Hang the fireplace on the wall mount
(drawing B), loosen the two screws
on the side of the fireplace so that the
glass plate can be removed (drawing
CD), place the stones supplied in the
fireplace (drawing E), replace the glass
plate onto the fireplace (drawing F),
tighten the screws and connect the
fireplace to the power supply.
E
F
Place the stones in the
fireplace
INSTRUCTIONS FOR USE
1. Turn on the fireplace at the on/off
switch. The remote control will only
work once this has been switched on.
Press on the power button
on the remote control to
turn on the heating function
and flame effect. When you
press on the power button
again, this will turn off the
heat function and flame
display (the fan will turn off
after 30 seconds) and the
fireplace is now in standby
mode.
2. Adjusting the intensity of the flame
In standby mode, press on the flame symbol
to activate the flame effect.
Or
In standby mode, press on the
flame symbol to activate the
flame effect (switch on the
lamp on the control panel). By
pressing again on the button,
the intensity of the flame is re-
duced. There are five different
intensities of flame, and you
can change between them by
pressing on the flame button.
Power
Flame
FLAME
