7
NookBox
Installation Guide
Keypad
Mounting Remote Keypad
To mount the remote keypad:
1. Remove the front cover.
2. Using the 2 mounting holes of the back cover as a template, mark off the positions in the most appropriate place.
3. Insert the wall plugs if fixing into plaster or brick surface.
4. Screw the Remote keypad onto the wall plugs.
5. Replace the front cover.
System Mode Control
After finish learning the Keypad into alarm system Control Panel, the user may change the system using Keypad.
There are two ways to arm the system.
1. Away Arm / Home Arm the system by entering Control Panel User PIN Code.
2. Away Arm / Home Arm the system without entering Control Panel User PIN Code.
Disarming the system always requires entering Control Panel User PIN Code.
KP-23B-F1 model Keypad supports both 4-digit and 6-digit PIN Code.
KP-23B model Keypad only supports 4-digit PIN Code
Arm/Home with Control Panel PIN Code
Under Test mode, Pressing
*
key and then
9
key to enable Arm/ Home with PIN Code function (
Default
).
»
Enter Arm Mode
:
Enter any one of Control Panel user code and press
key. If panel has no fault and arming is successful, the
Status Red LED will turn ON alone with a long beep.
»
Enter Home Mode
:
Enter any one of Control Panel user cods and
key. If panel has no fault and arming is successful,
the Status Red LED will flash 4 times alone with 3 beeps.
»
Return to Disarm Mode
: Enter any one of Control Panel user code and
key. If disarm is successful, the Status Blue LED will turn ON
along with 2 beeps.
Arm/Home without Control Panel PIN Code
In the Test mode, Pressing
*
key and then
8
key to enable Arm/ Home without PIN Code function
»
Enter Arm Mode
:
Press
key. If panel has no fault and arming is successful, the Status Red LED will turn ON alone with one
long beep.
»
Enter Home Mode
:
Press
key. If panel has no fault and arming is successful, the Status Red LED will flash 4 times alone with
3 beeps.
»
Return to Disarm Mode
: Enter any one of Control Panel user code and
Key. If disarm is successful, the Status Blue LED will turn
ON along with 2 beeps.
