5
NookBox
Installation Guide
Input and Output Switch DIO-52-ZBS
ZigBee Network Setup
ZigBee Device Guideline:
ZigBee is a wireless communication protocol that is reliable, has low power consumption and has high transmission efficiency. Based on the
IEEE802.15.4 standard, ZigBee allows a large amount of devices to be included in a network and are coordinated for data exchange and signal
transmission.
Joining the ZigBee Network:
As a ZigBee device, the Switch needs to join a ZigBee network to transmit signal when it is triggered. Please follow the steps below to add the
Switch into the ZigBee network.
1. Use the two-wired 12DC adapter or insert battery to power on the Switch.
2. After powering up, press and hold the Function button for 10 seconds, then release it to join the network. Please make sure the permit-join
feature on the router or coordinator of your ZigBee network is enabled.
3. If the Switch successfully joins a ZigBee network, the LED Indicator will flash twice to confirm.
4. After joining the ZigBee network, the Switch will be registered in the network automatically. Please check the ZigBee coordinator, system
control panel or CIE (Control and Indicating Equipment) to confirm if joining and registration is successful.
5. After joining the ZigBee network, if the Switch loses connection to current ZigBee network, the LED will flash every 20 minutes to indicate.
Please check your ZigBee network condition and Switch signal range to correct the situation.
Factory Reset:
If you want to remove the Switch from current network and join a new network, you need to use the Factory Reset function to clear the Switch
for its stored setting and information first before it can join another network. To perform Factory Reset:
1. Press and hold the function button for 10 seconds then release.
2. The Switch has been reset to factory default setting with all its previous network information removed. It will now actively search for
available ZigBee network again and join the network automatically.
3. If the Switch successfully joins a ZigBee network, the LED Indicator will flash twice to indicate.
Installation
The Switch can be installed on a flat surface. You can choose to mount the switch with or without bracket using screws or double-sided
adhesive tape.
Without Bracket:
1. Remove the front cover. Use the mounting holes on the back cover as template to mark mounting location.
2. Screw the back cover onto marked location, drill holes and install wall plugs if required.
3. Replace the front cover.
With Bracket:
1. Use the mounting holes on the mounting bracket as template to mark mounting location.
2. Screw the mounting bracket onto marked location, drill holes and install wall plugs if required.
3. Hook the switch onto the hooks on the bracket and slide upward to secure.
